LG Refrigerator LSC26905TT Manual

The LG LSC26905TT is a 26 cubic foot French Door Refrigerator featuring a sleek stainless steel design, Smart Cooling System™, Door Cooling+™, Smart Diagnosis™ system, LED lighting, adjustable gallon door bins, humidity-controlled crispers, and an external water and ice dispenser. It includes energy-saving modes, child lock, and various temperature controls for optimal food preservation. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Water Line 7. Using the Dispenser 8. Food Storage Tips 9. Care & Cleaning 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: French doors, external water/ice dispenser, LED interior lighting, adjustable shelves, humidity-controlled crispers, gallon door bins, and Smart Diagnosis™ system.

FeatureDescription
Smart Cooling System™Maintains consistent temperature and humidity
Door Cooling+™Circulates cool air to door bins
Smart Diagnosis™Helps diagnose issues via phone with LG support
LED LightingEnergy-efficient, bright interior lighting
External DispenserProvides chilled water and ice (cubed/crushed)
Adjustable ShelvesFlexible storage configurations
Humidity CrispersPreserves freshness of fruits and vegetables
Gallon Door BinsHolds large containers like milk jugs
Child LockLocks dispenser and control panel
Energy Saver ModeReduces energy consumption

Installation

Unpack and inspect contents. Ensure proper location with adequate clearance.

  1. Position refrigerator: Allow at least 2 inches clearance on sides and back for ventilation.
  2. Level the unit: Adjust front leveling legs to ensure doors close properly.
  3. Connect water line: For ice/water dispenser, connect to cold water supply using included kit.
  4. Plug into dedicated 120V AC outlet.

WARNING! Refrigerator is heavy; use two people for moving. Ensure floor can support weight.

First-Time Setup

Plug in refrigerator; allow 24 hours for cooling before adding food.

  1. Set temperatures: Use control panel to set fridge (recommended 37°F) and freezer (0°F).
  2. Enable ice maker: Press and hold Ice button for 3 seconds to activate.
  3. Run initial ice cycle: Discard first batch of ice (about 24 hours).
  4. Configure settings: Set door alarm, child lock, and energy saver as desired.

CAUTION! Do not overload shelves. Allow space for air circulation.

Specifications

Controls and Settings

Access controls via front panel or door display. Buttons: POWER, TEMP (Fridge/Freezer), ICE (Cube/Crush), LOCK, ENERGY SAVER.

Display Panel: Shows set temperatures, filter status, ice mode, and error codes.

Temperature Settings: Fridge (34°F–46°F), Freezer (-6°F–8°F). Ice Options: Cube or Crush. Special Modes: Energy Saver (reduces condensation), Child Lock (locks dispenser and controls), Door Alarm (sounds if door left open). Filter Reset: Hold Filter button 3 seconds after replacing water filter.

Connecting Water Line

Required for ice and water dispenser function.

  1. Turn off main water supply.
  2. Connect water line kit (included) to cold water pipe.
  3. Route line to refrigerator connection valve (avoid sharp bends).
  4. Connect line to refrigerator inlet (usually bottom rear).
  5. Turn on water; check for leaks.
  6. Flush line by dispensing water for 3 minutes.

Tip: Use only approved water line materials. Ensure connections are tight.

Using the Dispenser

Provides chilled water and ice (cube or crush).

  1. Select ice type: Press ICE button to toggle between cube and crush.
  2. Dispense ice: Press lever against glass (do not use hand).
  3. Dispense water: Press water button or lever.
  4. Child lock: Press and hold LOCK button for 3 seconds to disable dispenser.
  5. Replace filter: When Filter light illuminates, replace water filter (LT1000P).

WARNING! Do not touch dispenser lever with bare hands to avoid injury. Keep children away.

Food Storage Tips

Organize food for optimal freshness and energy efficiency.

Note: Do not block air vents. Allow hot food to cool before storing.

Care & Cleaning

Unplug before cleaning interior. Use mild detergent and water; avoid abrasives.

  1. Exterior: Wipe with damp cloth; use stainless steel cleaner for finish.
  2. Interior: Remove shelves and bins; wash with warm soapy water.
  3. Dispenser: Clean with soft cloth; run vinegar solution through water system annually.
  4. Condenser coils: Vacuum every 6 months (located at back or bottom).

CAUTION! Do not use harsh chemicals or steam cleaners. Never wash removable parts in dishwasher unless specified.

Regulatory Information

UL Listed; complies with FCC Part 15 Class B. Energy Star® certified. Copyright © LG Electronics. For support, visit www.lg.com or contact LG Customer Service at 1-800-243-0000. Model LSC26905TT manufactured for U.S. market. Proper disposal required per local regulations.

Troubleshooting

SymptomPossible CauseCorrective Action
Refrigerator not coolingPower/doors/settingsCheck power cord; ensure doors closed; verify temperature settings.
Dispenser not workingWater line/child lockEnsure water line connected; check child lock status; replace filter.
Ice maker not producing iceWater supply/temperatureCheck water line; freezer must be at 0°F or below; allow 24 hours.
Unusual noiseLeveling/fan/itemsLevel refrigerator; check for items touching back wall; clean condenser fan.
Water leakingLine connection/defrostTighten water line; check defrost drain for clog.
Display error codesSensor/system faultRefer to manual code list; use Smart Diagnosis™ or call support.

Reset: Unplug for 5 minutes, then plug back in to reset control board.

Service: 1-800-243-0000; www.lg.com

LG Refrigerator LSC26905TT Manual © - All Rights Reserved 2025